|
DIRECTIONS FOR CLEANING AFTER USE
- Leave
CYLINDER installed or insert blue plug in REGULATOR INLET. This
will prevent water from entering the REGULATOR INLET.
- Turn
entire Leland CO2 PicnicTap® upside down with the COUPLER
pointing up.
- Bring
the LOCKDOWN HANDLE to unlocked position. (up)
- Put
several drops of liquid dishwashing soap into the hole at the
bottom of the COUPLER. The soap will help neutralize the corrosive
nature of beer.
- Carefully
pour some warm water into the COUPLER and with your finger over
the hole, shake it to get the soap and water mixed in the ROD.
- Open
the FAUCET and pour some more water through the COUPLER, this
time with the FAUCET open. Rinse and leave everything open to
air dry completely.
- The
exterior needs warm soapy water sponged and then dried off after
a rinse.
IMPORTANT:
Do not immerse REGULATOR in water. It is a sensitive instrument
and will not work if wet.
Allow REGULATOR to thoroughly dry before use.
|
LUBRICATE
SPECIFIED AREAS WITH VASELINE ONLY.
(USE VERY SPARINGLY)
DO NOT USE ANY TYPE OF OIL OR AEROSOL LUBRICANT.
A
CLEAN, WELL MAINTAINED TAP WILL LAST FOR YEARS.
|
WARNING:
High pressure equipment must be repaired by our professionally trained
staff or our designated distributor using parts labeled for a Leland
CO2 PicnicTap®.
READ ALL WARNINGS CAREFULLY
|
